Top of Page

Broadcasts and Multicasts  Broadcasts and Multicasts
Domain Time II Client
Version 5.2

These are the broadcast and multicast addresses used by Domain Time Client.

CAUTION: The default settings on this page are correct for most situations. Only make changes if you are sure you need them and you fully understand the effects of the change.

Broadcasts and Multicasts are used for a variety of purposes by the various Domain Time components. For example:

  • Server uses them to send cascades and advisories
  • Server uses them as the listen addresses for IPv4 and IPv6 multicast requests
  • Server uses them to send broadcast/multicast time (using the DT2, NTP and PTP protocols)
  • Tools that don't have their own settings (for example, dtcheck.exe) use them for discovery and testing
  • Clients can use them to discover DT2, NTP, and PTP time sources
  • Clients use them as the listen addresses for IPv4 and IPv6 multicast requests

 

The settings on this page control whether Domain Time will enable multicasts and broadcasts and what addresses to use for these functions. Note, Domain Time joins multicast groups by default even if these settings are disabled. Also, multicasts will always be used if you enable PTP. Multicast group join settings are set on the Network property page.

 IPv4 Broadcasts 

 Enabled         Broadcast address:  

This section configures the Domain Time IPv4 Broadcast address.

    By default, Domain Time Client will use broadcasts only on subnets local to this machine. If you want to reach machines on remote subnets, you should enable multicast (see below).

     

     IPv4 Multicasts 

     Enabled
    TTL: 
    DT2 multicast address: 
    NTP multicast address: 

    This section configures the Domain Time IPv4 Multicast address.

      The TTL (Time-to-live) entry sets how many router hops a multicast should make when propagating through your network. Choose a value that allows your multicasts to reach all of your subnets. This is usually the only setting you should change in this section.

      Changing the multicast address listed here is usually an error.

     

     IPv6 Multicasts 

     Enabled
    Hop Count: 
    DT2 multicast address: 
    NTP multicast address: 

    This section configures the Domain Time IPv6 Multicast address.

      The Hop Count entry sets how many router hops a multicast should make when propagating through your network. Choose a value that allows your multicasts to reach all of your subnets. This is usually the only setting you should change in this section.

      Changing the multicast address listed here is usually an error.

     

    Next Proceed to the Security Settings page
    Back Back to the Network Settings page

Domain Time II Software distributed by Microsemi, Inc.
Documentation copyright © 1995-2024 Greyware Automation Products, Inc.
All Rights Reserved
All Trademarks mentioned are the properties of their respective owners.